Author: Peter Berger
Date: 07:04:21 07/24/04
Go up one level in this thread
On July 24, 2004 at 09:42:16, Kurt Utzinger wrote: >On July 24, 2004 at 09:36:19, Peter Berger wrote: > >>"Tablebases >> >>Gothmog now supports Nalimov endgame tablebases. In order to use >>them, you must specify the location of the tablebases on your hard >>disk in the gothmog.ini file. Unfortunately, it is not possible (yet) >>to configure the tablebase location through the UCI interface; even if >>you use Gothmog in UCI mode you must set the tablebase location in the >>init file." >> >>Have you followed this advice? Works for me. >> >>Peter > > > Hi Peter > Arena 1.08 and Gothmog were configured correctly > and it just happened what I reported. The above > advice must be wrong: there is no init-file but > only a ini-file I think. > Kurt It is a typo in the README file, I didn't correct for sake of correctness of quote. Even if you use Gothmog as an UCI engine you have to setup the tablebases in the gothmog.ini file. Then they will work - at least they do here.
This page took 0 seconds to execute
Last modified: Thu, 15 Apr 21 08:11:13 -0700
Current Computer Chess Club Forums at Talkchess. This site by Sean Mintz.