Author: Kurt Utzinger
Date: 22:51:31 12/02/05
Go up one level in this thread
On December 03, 2005 at 01:27:16, George Speight wrote:
>
>I want to change a particular setting in the parameters for an engine inside
>chessbase. I load the engine to play, and then open up its parameters. I make
>the change and then click "ok". The change has taken place. But then i load
>another engine to play and later go back and load the engine again that i made
>the setting change in. Now it has gone back to the original setting that was
>present before i made the change. What is the procedure i use that when i make
>the setting change it is permanent, and i dont have to worry about making it
>each time i load the engine. thanks in advance, George
Please consult the help file
of the Fritz-GUI.
Kurt
This page took 0 seconds to execute
Last modified: Thu, 15 Apr 21 08:11:13 -0700
Current Computer Chess Club Forums at Talkchess. This site by Sean Mintz.