Author: Dave Gomboc
Date: 11:51:24 04/22/99
Go up one level in this thread
On April 22, 1999 at 12:29:20, José de Jesús García Ruvalcaba wrote: >On April 20, 1999 at 21:44:00, Dave Gomboc wrote: > >> >>I am not very good with operating crafty from the command line: I could not tell >>it to "go to infinite time control mode and think on a move". > >Type 'analyze'. Other way is to use crafty via Xboard, and put it on 'analysis >mode'. I assume there is something similar in Winboard. It is the same, but the PV information gets replaced with each ply, instead of being listed. I discovered the problem under Winboard, and ran Crafty directly to get the output that was in the original message. >> But it seems like >>this ponder search should be sufficient. >> > >Most times the ponder search will not be sufficient. Sufficient for what? My sentence meant "sufficient for demonstrating that Crafty is perhaps not analysing the position as well as possible". I am not sure what "sufficient" means in your sentence. >>Dave > >I suggest you read the file 'crafty.doc', it has a full description of all >available crafty commands. I have read it before. It is far too long for wade through it on the rare occasions that I use the command line interface. I generally use the "help" command, and guessed that "analyze" would be for a whole game. >José. Dave
This page took 0 seconds to execute
Last modified: Thu, 15 Apr 21 08:11:13 -0700
Current Computer Chess Club Forums at Talkchess. This site by Sean Mintz.